Make sure the tables button is active. If the button is active make sure the window isn't resized to the bottom of the screen.
Changing the mode will set the thermostat into override mode and it will continue in the altered mode for the duration of the override timer. To return to the schedule after changing the mode you can either press the resume button or allow the override timer to end.
Why am I getting spikes in the graphing section of the Command Center and schedules are not firing properly?
Power cycle the controller and check to make sure you are running the most current version of the Command Center software.
The X1 and X2 terminals should be connected to the corresponding terminals on the thermostat. It is recommended to balance the number of connections to each of the four terminals on the controller. If you have an older controller with only three terminals balance the number of wires connecting to the two X1 terminals.
You must use CAT5 cable to wire the XBus terminals.
I had a power outage and now I cannot connect to some of my XBus/Strongmesh thermostats in the Command Center software. How do I get them back online?
In the event of a power outage or power surge, the thermostats may reset and go back to address 1. Check the thermostat addresses by holding the mode and fan buttons simultaneously for twelve seconds, this will show the address of the thermostat. Multiple thermostats with the same address will cause the controller not be able to communicate with them. In this case, set the thermostats back to the correct addresses. If you do not find a solution to the issue in this FAQ section, contact support.
I had a power surge and now my controller is not working properly. What could be the cause of this problem?
A power surge may damage the network controller and/or the thermostats. Check the NT-IPXB controller and make sure it has information scrolling across the LCD. Try logging in to the controller via IP address in a browser and see if it is showing up. If it is showing up, make sure all the settings are correct. If all settings are correct, try doing a power cycle on the controller.
If your equipment is 2-stage, first make sure your DIP switches are set correctly to allow second stage operation. In order to bring on second stage faster than the efficient fuzzy-logic algorithm (about 15-20min after first stage, if needed):